Download installation

Transcript
User Manual for POWERLINE 31 series power supply units
DIAGNOSTIC OPERATIONS FOR ERRORS REPORTED BY
THE UPS
Problem
Possible cause
The unit switched to an error
Solution
Make sure that the unit is not overloaded, the fans are not blocked,
Error code “08”,continuous state due to exceeding
and the surrounding temperature is not excessively high. Wait 10
sound signal
maximum permitted
minutes before powering on the unit in order for to cool it down. If
temperature
the problem was not eliminated, contact technical support.
Disconnect all receivers. Turn off the unit. Make sure that the
Error code “09”,continuous Short circuit on the unit’s
receivers are not damaged and check whether the UPS has no
sound signal
internal errors, and the reconnect the receivers. In the event of a
output
problem concerning the UPS, contact technical support.
Error code “05” or “06”,
The unit switched to an error
continuous sound signal
state due to an internal error
The UPS switches on in
Input voltage or frequency
battery mode (MODE “03”) exceeds permitted levels
Contact technical support
Check the power source
Check the receivers and disconnect non-critical receivers.
Error code “07”,
Receiver overload or short
Recalculate the power load and reduce the number of receivers
continuous sound signal
circuit.
connected to the unit. Check whether any of the receivers are
damaged.
Warning - code “23”,
sound signal every 1
second
Error code “11”,continuous
sound signal
The UPS does not operate
although the mains
voltage is correct
Damaged storage cells or
loader
Contact technical support
Low charge level of storage
cells or storage cells
Check the condition of storage cells
disconnected
service BYPASS switch
damaged
Contact technical support
The storage cells are not fully Leave the unit connected to the mains for at minimum 10 hours in
The battery support time
has become shorter
charged
order to fully charge the storage cells.
Unit overload
Check the receivers and disconnect non-critical receivers.
Storage cell capacity
decrease caused by aging
The “I” has been pressed for
an insufficient period of time
The unit does not switch
Press the “ON” button for at least 1 second
No storage cells are
on after pressing the “ON” connected to the unit or the
button
Replace the storage cells
voltage of storage cells is too
Check the connection of storage cells or charge the storage cells
low
Unit error
Contact technical support
When contacting technical support, please prepare the basic information:
- UPS model and series number
- when the problem occurred
- complete description of the problem, including error codes, sound signals, supply and load status. If you have a UPS designed for long backup
times, it is also required to prepare information about the batteries used.
2010/01/25
www.ever.eu
27