Download NOTE - Elevator Controls

Transcript
L6-01
L6-02
L8-07
L8-15
2
250 % (*)
0
0
A
A
A
A
Alarm @ Run on over-torque detection
Torque detection level
Output phase loss disabled
OL2 at low speeds disabled
Digital Inputs
These drive parameters configure the drive digital inputs to receive elevator control’s PVF
controller digital commands.
Parameter # EC Setting Terminal # Access Level Comments
H1-01
24
S3
A
External fault, N/O
H1-02
8
S4
A
External base-block N/O
H1-03
F
S5
A
Terminal not used
H1-04
F
S6
A
Terminal not used
H1-05
F
S7
A
Terminal not used
H1-06
7
S8
A
Fast Stop – decelerates using C1-08
Digital Outputs
These drive parameters configure the drive digital outputs to signal elevator control’s PVF
controller of drive operational mode.
Parameter # EC Setting Terminal # Access Level Comments
H2-01
0
M1 – M2 A
Drive on - closed during run
H2-02
5
M3 – M4 A
Output to turn on LSSM speed monitor
L4-01
10 Hz (*)
A
Freq to LSSM –Low speed safety
monitor
Analog Inputs
These drive parameters configure the drive analog inputs to receive elevator control’s PVF
controller S-Curve input.
Parameter # EC Setting Terminal # Access Level Comments
H3-01
0
A1
A
Speed reference input to term A1
H3-02
95 % (*)
A
Adjust to obtain rated speed
H3-09
1F
A2
A
Terminal A2 not used
H3-11
0.1
A
Terminal A2 Bias.
Adjust H3-02 to obtain rated car speed with rated speed input from the PVF as measured
with a tachometer.
Analog Outputs
These drive parameters configure the drive analog outputs to generate an actual car speed
curve profile from encoder speed feedback for speed monitoring purpose.
Parameter # EC Setting Terminal # Access Level Comments
H4-01
5
H4-07
1
FM
A
A
Motor speed output (TAC input to
PVF)
Set terminal FM output to +10 to –10
VDC
Model V900-PVF Traction Controller Installation & Adjustment Manual
83