Download NOTE - Elevator Controls
Transcript
L6-01 L6-02 L8-07 L8-15 2 250 % (*) 0 0 A A A A Alarm @ Run on over-torque detection Torque detection level Output phase loss disabled OL2 at low speeds disabled Digital Inputs These drive parameters configure the drive digital inputs to receive elevator control’s PVF controller digital commands. Parameter # EC Setting Terminal # Access Level Comments H1-01 24 S3 A External fault, N/O H1-02 8 S4 A External base-block N/O H1-03 F S5 A Terminal not used H1-04 F S6 A Terminal not used H1-05 F S7 A Terminal not used H1-06 7 S8 A Fast Stop – decelerates using C1-08 Digital Outputs These drive parameters configure the drive digital outputs to signal elevator control’s PVF controller of drive operational mode. Parameter # EC Setting Terminal # Access Level Comments H2-01 0 M1 – M2 A Drive on - closed during run H2-02 5 M3 – M4 A Output to turn on LSSM speed monitor L4-01 10 Hz (*) A Freq to LSSM –Low speed safety monitor Analog Inputs These drive parameters configure the drive analog inputs to receive elevator control’s PVF controller S-Curve input. Parameter # EC Setting Terminal # Access Level Comments H3-01 0 A1 A Speed reference input to term A1 H3-02 95 % (*) A Adjust to obtain rated speed H3-09 1F A2 A Terminal A2 not used H3-11 0.1 A Terminal A2 Bias. Adjust H3-02 to obtain rated car speed with rated speed input from the PVF as measured with a tachometer. Analog Outputs These drive parameters configure the drive analog outputs to generate an actual car speed curve profile from encoder speed feedback for speed monitoring purpose. Parameter # EC Setting Terminal # Access Level Comments H4-01 5 H4-07 1 FM A A Motor speed output (TAC input to PVF) Set terminal FM output to +10 to –10 VDC Model V900-PVF Traction Controller Installation & Adjustment Manual 83