Download GPIB Manual - wavecrest dts
Transcript
• RIGHTRJ The RIGHTRJ query returns the Random Jitter on the Right Side of the Total Jitter Histogram obtained from the previous acquisition. Since this tool uses a Tail-Fit to compute this value, a valid value may not always be available. If no current value is available, 9.99999E+37 is returned as the measurement result. Query syntax- :HISTogram:RIGHTRJ? Example: Response: Example: Send(0,5,":HIST:RIGHTRJ?",14,EOI); <ASCII floating point> 3.637e-12 • RJ The RJ query returns the Random Jitter obtained from the previous acquisition. Since this tool uses a Tail-Fit to compute this value, a valid value may not always be available. If no current value is available, 9.99999E+37 is returned as the measurement result. Query syntax- :HISTogram:RJ? Example: Response: Example: Send(0,5,":HIST:RJ?",9,EOI); <ASCII floating point> 3.637e-12 • STDDEV The STDDEV query returns the standard deviation of all measurements across all accumulated histogram passes. Query syntax- :HISTogram:STDDev? Example: Response: Example: Send(0,5,":HIST:STDD?",11,EOI); <ASCII floating point> 3.216345e-012 • TAILFIT:COMPLETE The TAILFIT:COMPLETE query provides a means to determine if the Tail-Fit has been completed. The Tail-Fit operation is an iterative process, and multiple acquires will be required before RJ, PJ, & TJ results are available. A value if 1 indicates the Tail-Fit is complete, a value of 0 indicates additional acquires are required. Query syntax- :HISTogram:TAILfit:COMPlete? Example: Response: Send(0,5,":HIST:TAIL:COMP?",16,EOI); <0|1> • TAILFIT:MINHITS The TAILFIT:MINHITS command selects the number of hits which must be accumulated before a Tail-Fit is attempted. This can be used to speed acquisition times if some minimum number of hits is required. This value is specified in 1,000’s of hits, so a value of 1 means 1,000 hits. The TAILFIT:MINHITS query returns the currently selected number of minimum hits. This value is specified in 1,000’s of hits, so a value of 1 means 1,000 hits. Command syntax- :HISTogram:TAILfit:MINHITS<0 to 10000> Example: Send(0,5,":HIST:TAIL:MINHITS 0",20,EOI); Query syntax- :HISTogram:TAILfit:MINHITS? Example: Response: Example: Send(0,5,":HIST:TAIL:MINHITS?",19,EOI); <ASCII integer> 50 230 | Section 6 | Tool Oriented GPIB Commands ©WAVECREST Corporation 2005
Related documents
Dazzler User Guide
PAPI - Wavecrest SIA Corporation is now handling sales and service
PLL Analysis Tool Quick Reference Guide
USER'S GUIDE to PROGRAM DBWS-9807a RIETVELD
Custom WaveView User Guide
ENDURO CUP
HF Modulation Analysis
SIA-3000 User`s Guide and Reference Manual
User Manual - File Management
Tektronix TDS8000 Digital Sampling Oscilloscope
Cyfin Reporter Manual
Cyfin Reporter Manual - Center