Download Custom WaveView User Guide

Transcript
16
16
Using the Coherent Sample Only (CSO) ADC
Toolbox
This chapter contains information on how to use the CSO ADC Toolbox.
To start the ADC Toolbox in the CSO mode, set the SW_SX_ORG_ADC shell
environment variable.
Input Signal Requirements
The input waveform for the CSO ADC Toolbox must have its signal strength in
integer code values (for example, 0 to 63 for a 6-bit ADC). Run a simulation on
an ADC design first and then convert the ADC output codes into an acceptable
waveform.
Preparing the Input Waveform
As depicted in the flow chart below, the following steps demonstrate how to use
Custom WaveView to convert the simulated ADC output code (in analog
waveforms) to an acceptable input signal for the CSO ADC Toolbox.
Custom WaveView User Guide
F-2011.09-SP1
189