Download Chapter 5_FlowSimulation

Transcript
Royal Haskoning
Triwaco User's Manual
The parameters representing the aquitards don't need any modification. The input file can be generated as
usual selecting 'Generate input' from the 'Calibration' pull down menu. It is recommended to check the input
file and to remove the lines defining the parameter TXx, which may appear in the input file if both TXx and
PXx are defined in the same data set.
Recharge and rewetting
The recharge is computed for each cell from the corresponding Triwaco parameter (generally top system
parameter RP1). By default recharge is supposed to take place in the uppermost active cell (NRCHOP = 3 in
the RCH1 package).
Unlike Triwaco ModFlow allows cells to go dry if the water table falls below the base of the aquifer (in
Triwaco only the uppermost layer may become dry, resulting in a zero value for this aquifer's transmissivity).
For cells that become dry the value of 1.0 E+32 is assumed, signifying the cell is inactive and does not
participate in the groundwater flow.
However, whenever the water table rises above the aquifer's base elevation the cell should participate in the
groundwater flow again. This process is called 'rewetting' and is supposed to be active. Values for the
rewetting threshold and the frequency of updating are fixed.
Rivers
Streams and rivers are usually defined by line elements and will be converted to a combination of ModFlow's
DRAIN- and GHB-package, thus accounting for differences in drainage and infiltration resistances. Generally
this approach will be permitted as long as the groundwater head does not fall below the bottom level of the
river. However, in cases very low groundwater heads may be expected the linear relation between the head
difference and the infiltration flux is not valid any more. In that case the RIV-package should be used in stead
of the GHB-package.
The user can specify which line elements are to be defined by the RIV-package by adding the parameter
BRx and modifying Rax.
For those rivers that should be converted to the RIV-package, the river activity parameter RAx should be set
to 3. In addition the parameter BRx is added, representing the river's bottom elevation. This parameter can
be added selecting 'Add' 'User Defined' from the 'Parameter' pull down menu and filling in the parameter
definition window. After having allocated all parameters the input file can be generated as usual.
5 Execution of Groundwater Flow Simulations: FLAIRS and MODFLOW-35