Download - SIMetrix
Transcript
Chapter 11 Command and Function Reference A table with the number of rows and columns equal to the number of logic families listed in the header. The columns represent outputs and the rows inputs. The entry in the table specifies the compatibility between the output and the input when connected to each other. The entry may be one of three values: OK Fully compatible WARN Not compatible but would usually function. Warn user but allow simulation to continue. Not compatible and would never function. Abort simulation. ERR In-In resolution table A table with the number of rows and columns equal to the number of logic families listed in the header. Both column and rows represent inputs. The table defines how inputs from different families are treated when they are connected. The entry may be one of four values: ROW Row take precedence COL OK ERR Column takes precedence Doesn't matter. (Currently identical to ROW) Incompatible, inputs cannot be connected. Out-out resolution table A table with the number of rows and columns equal to the number of logic families listed in the header. Both column and rows represent outputs. The table defines how outputs from different families are treated when they are connected. The entry may be one of four values: ROW COL OK Row take precedence Column takes precedence Doesn't matter. (Currently identical to ROW) ERR Incompatible, outputs cannot be connected. Reset Reset Frees memory associated with most recent simulation run. It is not normally necessary to use this command unless available memory is low and is needed for plotting graphs or other applications. Note that Reset does not delete the data generated by a simulation only the internal data structures set up to perform a run. These are automatically deleted at the beginning of a new run. SaveRhs SaveRhs [/nodeset] filename Creates a file containing every node voltage, inductor current and voltage source current calculated at the most recent analysis point. The values generated can be read back in as nodesets to initialise the dc operating point solution. 295