Download Bosch 940ESO Specifications
Transcript
Problem solving Display Cause Solution Ionization failure during operation. 1. Check gas type, see Fig. 2, page 6. 2. Check three wire connections to ignition group on the lower front of the heat exchanger are secure. 3. Check vent openings for blockage. Improper venting may cause unstable burner flames and loss of flame ionization. 4. Check that the minimum power fan speed has been adjusted to the proper value. See page 29. 5. Check gas pressure, see section 6.6, page 24. 6. Check and adjust CO2 readings, see section 9.4, page 33. Internal hardware/software failure. 1. Disconnect power supply cord and check the two wire and ground connections on control board as well as ground connection on heater chassis. 2. Pushing the wrong combination of buttons on the control unit can create confusion among the microprocessors inside. In this case, the error code should not happen more than once or twice. Turn off the water heater. Turn water heater back on and try resetting error code. Use the reset button ( ) to reset any error codes. 3. Possible defective control unit. Call Bosch Water Heating for further instructions. Ionization error at standby. 1. Loose connection to the flame ionization rod. Verify that the thinner wire leading from the control unit is securely connected to the flame sensor located on the lower front of the heat exchanger. See Fig. 65, page 47. 2. Flame ionization rod or control unit may be damaged. Contact Bosch Water Heating for further instruction. Gas leakage error, gas valve circuit not closing properly. 1. Disconnect power supply cord and check wire connections on gas valve and the two connectors on the control board. 2. Flow water out of a hot water tap above the minimum activation point of 0.5 GPM. Measure voltage at the gas valve wire plug connection. The voltage should measure 24VDC between the left pair of wires and 24VDC between the right pair of wires when the unit is operating. If voltage is not proper, contact Bosch Water Heating for further instruction. 3. Gas valve may be defective, contact Bosch Water Heating for further instrucation. Table 12 * By installer or service technician only. 42 6 720 644 956