Download Dell Force10 Command Line Reference Guide
Transcript
Defaults interval minutes (OPTIONAL) Enter the keyword interval followed by the time period in minutes at which ACL logs must be generated. The interval range is from 1 to 10 minutes. monitor (OPTIONAL) Enter the keyword monitor when the rule is describing the traffic that you want to monitor and the ACL in which you are creating the rule is applied to the monitored interface. By default, 10 ACL logs are generated if you do not specify the threshold explicitly. The default frequency at which ACL logs are generated is five minutes. By default, flow-based monitoring is not enabled. Command Modes Command History Usage Information CONFIGURATION-STANDARD-ACCESS-LIST Version 9.4(0.0) Added support for flow-based monitoring on the MXL 10/40GbE Switch IO Module platforms. Version 9.3(0.0) Added support for logging of ACLs on the MXL 10/40GbE Switch IO Module platforms. When the configured maximum threshold is exceeded, generation of logs is stopped. When the interval at which ACL logs are configured to be recorded expires, the subsequent, fresh interval timer is started and the packet count for that new interval commences from zero. If ACL logging was stopped previously because the configured threshold is exceeded, it is re-enabled for this new interval. If ACL logging is stopped because the configured threshold is exceeded, it is reenabled after the logging interval period elapses. ACL logging is supported for standard and extended IPv4 ACLs, IPv6 ACLs, and MAC ACLs. You can configure ACL logging only on ACLs that are applied to ingress interfaces; you cannot enable logging for ACLs that are associated with egress interfaces. You can activate flow-based monitoring for a monitoring session by entering the flow-based enable command in the Monitor Session mode. When you enable this capability, traffic with particular flows that are traversing through the ingress and egress interfaces are examined and, appropriate ACLs can be applied in both the ingress and egress direction. Flow-based monitoring conserves bandwidth by monitoring only specified traffic instead all traffic on the interface. This feature is particularly useful when looking for malicious traffic. It is available for Layer 2 and Layer 3 ingress and egress traffic. You may specify traffic using standard or extended access-lists. This mechanism copies all incoming or outgoing packets on one port and forwards (mirrors) them to another port. The source port is the monitored port (MD) and the destination port is the monitoring port (MG). Related Commands deny — assigns a IP ACL filter to deny IP packets. ip access-list standard — creates a standard ACL. 236 Access Control Lists (ACL)
Related documents
Dell Force10 S4810P Command Line Reference Guide
Dell Networking S6000 Command Line Reference Guide
Dell Networking S5000 Command Line Reference Guide
Dell Networking S6000 Configuration manual
Dell Networking Z9500 Command Line Reference Guide
Dell Force10 Z9000 Configuration manual
Dell Networking Z9500 Configuration manual
Dell Force10 Z9000 Addendum
Dell Force10 S4810P Configuration manual
ZXR10 5900E Series All Gigabit-Port Intelligent Routing Switch
6 Switch Stack System
Dell Networking Z9000