Download HP Integrity NonStop H-Series Command Reference Guide
Transcript
HP NonStop Shadowbase Command Definitions Consumer Command Descriptions have purged a Collector’s RESTART file. For this reason, you may want to start HP Shadowbase with the pulse feature disabled (i.e.,i.e., PULSERATE 0) and then alter the Consumer to enable them after successful startup. When enabled (i.e.,i.e., PULSERATE is > 0), the first pulse is not sent until the PULSERATE interval expires. If you want one to be sent before this period expires, use the Consumer’s PULSE command to send a pulse on demand. The default is 0 which means pulses will not be generated for this Consumer. The valid range is 0 through 1209600 (14 days in seconds). When greater than zero, the specified value must be longer than the amount of time that the pulse will be tracked (a pulse is tracked while the AUDMON is waiting for the ACK to come back). In other words, only one pulse is “tracked” at a time, and another one cannot be sent until that pulse is no longer being “tracked”. The maximum amount of time that the AUDMON will track the pulse and wait for the ACK is defined by the PULSEWAIT and PULSEWAITREPEATS parameters. The pulse ACK is tracked for a maximum of (PULSEWAIT * (PULSEWAITREPEATS + 1)) seconds. Another pulse cannot be sent until this time expires, or the ACK for the pulse comes back. The pulse generation rate must be set greater than this time (PULSERATE must be set greater than this number). Note that any pulse ACKs that come back after this time expires are still processed and stored in the pulse file. The PULSEWAIT can be set to 0, which means that the pulse ACK will not be timed (or alarmed). When PULSEWAIT is 0, the PULSERATE can be set to any frequency desired. HP Shadowbase includes an edit to make sure that you do not set the pulse generation (PULSERATE) and ACK wait intervals (PULSEWAIT, PULSEWAITREPEATS) “too short” to cause extra overhead or alarming. This parameter can be altered at any time. To disable the pulse feature, alter PULSERATE to 0. PULSESVRCLOCKADJ Initial Version 3.990 Changed Version <microseconds> Values Default 0 Client Server Minimum -2147483647 Extended Maximum 2147483647 Open Target HP NonStop Shadowbase Command Reference Manual—785421-002 152 Alter Yes