Download INSTALLATION MANUAL
Transcript
INSTALLATION DIAGRAM OF INDOOR AND OUTDOOR UNITS Do not allow the drain hose to get slack. 70 mm or more 1 Air filter Installation plate Cut the piping hole sloped slightly. 50 mm or more 50 mm or more 6 Filter Make sure to run the drain hose sloped downward. 5 Filter The auxiliary piping can be connected to the left, rear left, rear right, right, bottom right or bottom left. 3 Batteries Shield pipe Right 2 Wireless remote control 8 Pan head wood screw 4 Remote control holder Left Rear right Bottom right Rear left Bottom left Vinyl tape Apply after carrying out a drainage test. 9 Insulation sheet 600 mm or more only when unobstructed to the front and both sides. Remark : (D) 100 CAUTION In case of right or left piping mm or Extension drain hose (Not available, provided by installer) re mo (B) Install in rooms that are 13 m3 or larger. If a leak of refrigerator gas occurs inside the room, an oxygen deficiency can occur. 600 or Cut dot-line area mo re Fixing bolt arrangement of outdoor unit RAS-10, 13, 18SAV Series Parts name Q’ty A Refrigerant piping Liquid side : ∅6.35 mm Gas side : ∅9.52 mm (RAS-(B) 10, 13UFV Series) : ∅12.7 mm (RAS-(B) 18UFV Series) One each • Secure the outdoor unit with fixing bolts and nuts if the unit is likely to be exposed to a strong wind. • Use ∅8 mm or ∅10 mm anchor bolts and nuts. • If it is necessary to drain the defrost water, attach drain nipple and cap water proof to the bottom plate of the outdoor unit before installing it. 108 mm 125 mm 28 mm Air inlet 320 mm 25 mm Part code Putty, PVC tapes mm (A) Optional Installation Parts C 8 mm thick heat resisting polyethylene foam Saddle (C) 600 B or m 100 mm or mo re • Detail of accessory and installation parts can see in the accessory sheet. Pipe insulating material (polyethylene foam, 8 mm thick) ore mm 1 One each * Drain nipple and cap water proof are packed in outdoor unit. 102 mm When installing the outdoor unit, leave open in at least two of direction (A), (B), (C) and (D) shown in the figure on the right. 86 mm 7 Mounting screw Insulate the refrigerant pipes separately with insulation, not together. Air outlet 90 mm 600 mm Drain outlet X When using a multi-system outdoor unit is used, refer to the installation manual provided with the model concerned. 3 Toshiba 1112150201 (EN)