Download User Guide

Transcript
Optidrive E2 Single Phase Output User Guide V3.10
1
Earth
L1 L2
L N
Fuses or MCB
Introduction
AC Supply Voltage
(50/60Hz)
Supply Voltage:
- 115, 230V
- 1 phase
- check drive rating information on page 27
Fuses or MCB & cable sizes:
- check drive rating information on page 27
Mechanical Mounting:
- Information can be found on page 9
Keypad Operation can be found on page 16
Control Terminals:
Based on default settings out of the box 1. Connect a START/STOP switch from Terminal 1
to 2.
Close the contact START (enable) the drive
Open the contact STOP the drive.
2. Connect a 10kΩ potentiometer on terminal 5, 6
& 7 to vary the speed from 0 to 50Hz (60Hz for HP
drives)
Stop - Run
10kΩ
Speed Pot
Motor cable sizes:
- check drive rating information on page 27
Motor Connection:
- check Motor connection detail on page 13
Motor Nameplate Details:
- Enter motor rated voltage (V) in P-07
- Enter motor rated current (A) in P-08
- Enter motor rated frequency (Hz) in P-09
See page 17 for further information on motor settings
www.invertekdrives.com
2