Download User Guide
Transcript
Optidrive E2 Single Phase Output User Guide V3.10 1 Earth L1 L2 L N Fuses or MCB Introduction AC Supply Voltage (50/60Hz) Supply Voltage: - 115, 230V - 1 phase - check drive rating information on page 27 Fuses or MCB & cable sizes: - check drive rating information on page 27 Mechanical Mounting: - Information can be found on page 9 Keypad Operation can be found on page 16 Control Terminals: Based on default settings out of the box 1. Connect a START/STOP switch from Terminal 1 to 2. Close the contact START (enable) the drive Open the contact STOP the drive. 2. Connect a 10kΩ potentiometer on terminal 5, 6 & 7 to vary the speed from 0 to 50Hz (60Hz for HP drives) Stop - Run 10kΩ Speed Pot Motor cable sizes: - check drive rating information on page 27 Motor Connection: - check Motor connection detail on page 13 Motor Nameplate Details: - Enter motor rated voltage (V) in P-07 - Enter motor rated current (A) in P-08 - Enter motor rated frequency (Hz) in P-09 See page 17 for further information on motor settings www.invertekdrives.com 2