Download User Guide

Transcript
Optidrive ODV-2 User Guide Revision 1.00
Optidrive HVAC Start Up Guide
OPTIDRIVE HVAC (Frame Sizes 4 to 7).
Mechanical Mounting
Information can be found on page 9,
section 3.5.
HVAC Display
(Status, Diagnostics, and Programming)
Keypad Operation can be found on
page 13, section 5.1
Control Terminal
Configuration based on factory settings
Safe Torque Off (STO)
Link the terminals as shown above
through the emergency stop circuit
contacts
Supply Voltage
Run / Stop 10K Pot
Close the switch to run (enable)
Open the switch to stop
Motor Cable
For correct cable size, see Technical
Data on page 34, section 11.4.
Observe the maximum permissible
motor cable length.
For Motor cable lengths > 50 metres, an
output filter is recommended.
Use a screened (shielded cable). The
shield should be bonded to earth at
both ends.
Fuses or MCB
Check Drive
Rating info on
Page 34,
section 11.4
PE
L1 L2 L3
AC Supply Connection
200 – 240 Volts + / - 10%
380 – 380 Volts + / - 10%
Check Drive Rating info on Page
34, section 11.2
2
M
www.invertek.co.uk
Motor Connection
Check for Star or Delta Connection.
Enter the Motor Nameplate Data into
the drive Parameters as follows:
Motor Rated Voltage: P1-07
Motor Rated Current: P1-08
Motor Rated Frequency: P1-09
Motor Rated Speed (Optional): P1-10