Download HSPICE Simulation and Analysis User Guide

Transcript
Chapter 5: Sources and Stimuli
Independent Source Elements
Parameter
Description
<RDC=val>
(DC analysis) Series resistance (overrides z0).
<RAC=val>
(AC analysis) Series resistance (overrides z0).
<RHBAC=val>
(HSPICE RF HBAC analysis) Series resistance
(overrides z0).
<RHB=val>
(HSPICE RF HB analysis) Series resistance (overrides
z0).
<RTRAN=val>
(Transient analysis) Series resistance (overrides z0).
<power=[0 | 1 | 2 | W | dbm]> (HSPICE RF) power switch
■
When 0 (default), element treated as a voltage or
current source.
■
When 1 or W, element treated as a power source,
realized as a voltage source with a series
impedance. In this case, the source value is
interpreted as RMS available power in units of Watts.
■
When 2 or dbm, element treated as a power source
in series with the port imedance. Values are in dbms.
You can use this parameter for transient analysis if the
power source is either DC or SIN.
Example
For example, the following port element specifications identify a 2-port network
with 50-Ohm reference impedances between the "in" and "out" nodes.
P1 in gnd port=1 z0=50
P2 out gnd port=2 z0=50
Computing scattering parameters requires z0 reference impedance values.
The order of the port parameters (in the P Element) determines the order of the
S, Y, and Z parameters. Unlike the .NET command, the .LIN command does
not require you to insert additional sources into the circuit. To calculate the
requested transfer parameters, HSPICE automatically inserts these sources as
needed at the port terminals. You can define an unlimited number of ports.
128
HSPICE® Simulation and Analysis User Guide
Y-2006.03