Download Operating Instructions
Transcript
Setpoint channel and closed-loop control 7.3 V/f control 7.3.1 Voltage Boost Description With low output frequencies, the V/f characteristics yield only a small output voltage. With low frequencies, too, the ohmic resistance of the stator windings has an effect and can no longer be ignored vis-à-vis the machine reactance. With low frequencies, therefore, the magnetic flux is no longer proportional to the magnetization current or the V/f ratio. The output voltage may, however, be too low to: ● Magnetize the induction motor. ● Maintain the load. ● Compensate for the voltage losses (ohmic losses in the winding resistors) in the system. ● Induce a breakaway / accelerating / braking torque. You can choose whether the voltage boost is to be active permanently (p1310) or only during acceleration (p1311). 'UYRXWS,BPD[ U 8BERRVWWRWDO U 3HUPDQHQWYROWDJHERRVW 8BERRVWSHUP S 0RW,BUDWHG S 8BERRVWDFFHO S 5DPSXSDFWLYH S 5BVWDWRUDFWLYH U 9ROWDJHERRVWRQ DFFHOHUDWLRQ Figure 7-5 Voltage boost total Note The voltage boost affects all V/f characteristics (p1300) from 0 to 6. NOTICE If the voltage boost value is too high, this can result in a thermal overload of the motor winding. Drive converter cabinet units Operating Instructions, 10/2008, A5E00189855A 261
Related documents
Istruzioni per l`uso
Operating Instructions
Conversores de frequência montados em unidade de
Istruzioni per l`uso
Velocity Edge GX440 Operating instructions
1785-6.5.22, ControlNet PLC-5 Programmable Controllers, User
Istruzioni per l`uso Edizione 11/2003 - Service, Support
Panel de mando AOP30 Cabinet Modules
A1 Control Workplace Hazards - SOL*R
Braking Module/Resistencia de freno
Construcción del armario y CEM
Filtro de red