Download Operating instructions

Transcript
Product description
2.5
Control devices
2.5 Control devices
Operating pressure
transmitter
The operating pressure transmitter (1) controls the operation of the compressor within the set switching limits.
Switch-on pressure pmin
If the network pressure drops
to the set switch-on pressure
pmin, the compressor switches
on.
Switch-off pressure pmax
If the network pressure increases to the switch-off
pressure pmax, the compressor either switches off (intermittent operation) or switches
to idling operation (continuous operation).
Fig. 2.5: Operating pressure transmitter
2.6 Safety and monitoring devices
General information
The safety devices guarantee a high degree of operational safety, in connection with the BOGE monitoring system.
When one of the safety devices responds, the control system reacts as follows:
– The compressor is immediately switched off.
– A flashing fault number in the left field of the display indicates the cause of
the fault.
Caution: Risk of injury!
Do not operate the compressor without built-in safety devices!
Do not dismantle the safety devices or put them out of operation!
The following monitoring devices are standard for BOGE control systems:
Safety temperature
limiting device
The safety temperature limiting device switches the compressor off as soon as
the maximum permissible final compression temperature has been reached.
If the temperature drops below the minimum temperature, the compressor will
not start. In the event that the safety temperature limiting device intervenes in
compressor operation:
1. Switch off the compressor (OFF button).
2. Acknowledge fault.
3. Rectify the fault.
4. Switch on the compressor (ON-button).
BOGE operating instructions for screw compressors Series SLF 30-3...SLF 125-3
Page 23