Download OPERATING INSTRUCTIONS

Transcript
2.
Safety Instructions.
All work on compressors and refrigeration systems shall be carried out only by refrigeration personnel who have
been trained and instructed in all work. The qualification and expert knowledge of the refrigeration personnel
corresponds to respectively valid guidelines.
We recommend hanging a large sheet of paper on the rack (and labelling this sheet) indicating the systems condition
during commissioning process, e.g. System in pressure/leak test, System Under 1st Evacuation with all inline
valves fully open, System under electrical controls circuits test etc. This assists with completing the commissioning
worksheet and informs site personal and site Safety Officer of the progress of the commissioning.
All plumbing work on the [Optional] Hot Water BPHE shall be carried out only by licensed accredited plumbing
personnel who has been trained and instructed in all work. The qualification and expert knowledge of the plumbing
personnel corresponds to respectively valid guidelines. See 9:10
The BITZER CO2 Hybrid Rack is constructed according to the state of the art and valid regulations. Particular
emphasis has been placed on the users’ safety.
Retain these Operating Instructions during the entire lifetime of the BITZER CO2 Hybrid Rack.
2.1 Residual hazards
Certain residual hazards from the BITZER CO2 Hybrid Rack are unavoidable. All persons working on these units
must therefore read these Operating Instructions carefully!
2.2
Safety References
ATTENTION!
Instructions on preventing possible damage to equipment.
CAUTION!
Instructions on preventing minor hazard to persons.
WARNING!
Instructions on preventing a possible severe hazard to persons.
DANGER!
Instructions on preventing an immediate risk of severe hazard to persons.
2.3
General safety references
WARNING!
The BITZER CO2 Hybrid Rack is under pressure with a holding charge of nitrogen to a pressure
of 1000 kPa above atmospheric pressure, incorrect handling may cause injury to skin and eyes. Wear
safety goggles while working on compressor. Do not open connections before pressure has been
released.
CAUTION!
During operation surface temperatures exceed 60°C or fall below 0°C. Serious burns and frostbite are
possible. Switch off and allow cooling down before working on the compressor and associated pipework.
CAUTION!
Compressors contain oil & refrigerant under pressure. Release pressure from both high & low side of
compressor before servicing.
CAUTION!
Tube brazing & compressor operation can produce hot surfaces. To avoid burns, allow surfaces to cool
down before continuing installation or servicing.
2
BAO-103-1 AUS