Download advanced driver assistance systems

Transcript
Y62 Patrol New Model Introduction
Nissan Australia. January 2013
VK56VD ENGINE CONTROL
VQ Inputs to ECM
23. Engine Oil Temp Sensor (EOTS)
The EOTS is used to detect the engine oil temperature.
The ECM utilises the signal for protection of the CVTC
system. (Continuously Variable valve Timing Control)
This is also an important input to the VVEL system. If the
Engine Oil Temperature reaches an excessively high
level (approximately 140 deg C), the engine will run in a
decreased power mode until the temperature stabilises.
24. Transmission Activity.
Communication via the CAN network between the ECM
& the TCM is constantly taking place.
The Transmission output speeds, gear position etc. is
shared with the ECM.
The Engine‟s activity such as Engine speeds &
temperature as well as the drivers commands
(Accelerator Pedal activity) is shared with the
Transmission.
NOTE:
The Park / Neutral signal is a separate input, refer to
ECM input no. 16 for more detail.
25. VDC & TCS Activity.
Communication from the ABS / TCS / VDC Control Unit
is sent to the ECM via CAN communication.
When the vehicle is un-stabilised due to excessive wheel
slip being detected or the vehicle is sliding sideways etc.,
the ECM assists with re-stabilising the vehicle by control
of the throttle valve (ETC) in order to reduce engine
power output.
NOTE:
VDC = Vehicle Dynamic Control
49