Download Appendixes
Transcript
1.1 Searching for Faults Automatically ••• Full Auto Mode/Auto Mode In the Full Auto mode, the optimum Distance range and Pulse width values are found by the MW9070B. In the Auto mode, measurment is performed using the values for these parameters set at the Setup screen. For details, see section 4.1. Measurement Conditions Search Results Appendixes Maintenance Performance Test Operation Setting Up Trace Waveform Before Use In this mode, faults in the cable are detected and displayed after about 3 minutes just by pressing the [Start] key. Set the measurement mode at the Setup screen to Full Auto or Auto, then the following screen is displayed when measurement is finished. Faults are indicated by the (event) symbol and the fault data is displayed under the waveform. The faults are called events and this display is called an Event Table. Outline 1.1 Searching for Faults Automatically •••Full Auto Mode/Auto Mode Event Table • Trace Waveform The trace waveform is displayed with the attenuation on the yaxis and the distance on the x-axis. The left end of the trace display is the OTDR optical output and the right end is the far end of the fiber cable. The symbol is displayed at faults in the cable. • Measurement Conditions Index Light Wavelength (λ), Distance Range (DR), Pulse Width (PW), Index of Refraction (IOR), Number of Averagings (Average) • Search Results Total number of Faults (Total), Total Fiber Length (Fiber Length), Total Loss of Entire Fiber (Total Loss) • Event Table Number of Fault counted from Left (No.), Distance from OTDR (Position), Splice Loss, Return Loss (R. Loss), Total Loss to the Fault (T. Loss) 3