Download Loadable Firmware - Hilscher Knowledge Base

Transcript
Descriptions and Requirements
2.1.5
13/59
Boot Procedure in Flash-Based netX Devices
ROM Loader and Second Stage Bootloader
After power-on reset at the netX device, the ROM Loader (which is a
hardware function and always present in the netX) is started. The ROM
loader initializes the netX controller and its optional non-volatile boot
devices such as serial or parallel Flash etc. It also executes the Second
Stage Bootloader, which is stored in the serial Flash memory of the netX
device, by copying it into the internal RAM of the netX.
Figure 4: ROM Loader After Power-On Reset
Second Stage Bootloader
The Second Stage Bootloader is necessary to get a netX based hardware
basically running and to set up a file system in the flash memory. In case
no firmware is available in the serial flash memory, it also sets up the dualport memory and creates a so-called "system device" or "system channel"
in the DPM by which the firmware can be downloaded from a host.
The Second Stage Bootloader also checks and reads the security
memory on the netX device.
Figure 5: SSBL After Power-On Reset
Loadable Firmware | How To Use Loadable Firmware
DOC090903AN05EN | Revision 5 | English | 2015-01 | Released | Public
© Hilscher 2009 - 2015