Download View - Net
Transcript
D 500 The pump is running and then is showing a warning or fault message Incident Warning W16 ADP TEMP. LOW Pump temperature is < of 15°C to the temperaturecontrol setting value Warning Cause Temperature control valve supply problem Troubleshooting y Other problem Incorrect monitoring configuration Check the temperature control valve connection on Therm. ADP connector (see D 10). Call customer service center. y W18 LOAD-LOCK PUMP Check that “LL PUMP OPTION” is not valid. (see C 42). LI1 and LI3 logic inputs are not used to monitor a LL pump LL pump problem W18 LOAD-LOCK PUMP Wiring problem LI1 and LI3 logic inputs are used to monitor a LL pump Other problem Call customer service center. y Check the connections on LI1 and LI3 connectors (see D 10). Call customer service center. The maintenance threshold of a parameter is reached y Check maintenance thresholds. Call customer service center. The maintenance threshold of a parameter is reached y Check maintenance thresholds. Call customer service center. The maintenance threshold of a parameter is reached y Check maintenance thresholds. Call customer service center. Warning Warning W31 ADP LP MAINT. The maintenance threshold of a parameter is reached y Check maintenance thresholds. Call customer service center. Warning The maintenance threshold of a parameter is reached y Check maintenance thresholds. Call customer service center. Incorrect M4 configuration y Configure for “ADP 122“ or “ADS“ (see C 42). Warning W28 LOAD-LOCK MAINT. Warning W29 ROOTS MAINT. Warning W30 EXHAUST MAINT. W32 ADP MAINT. Fault on ADS 1202/1802 D34 AR.URGT; CONT.ADP Fault D35 EMERGENCY STOP 6/7 Other problem Pump emergency stop is engaged Other problem Call customer service center. y Rotate to unlock the emergency stop on the front panel display. Call customer service center. adixen Vacuum Products - Operating instructions - ADP/ADS Series Two G 03219 - Edition 01 - December 06 Warning