Download Process CPU User`s Manual(Function Explanation
Transcript
7 FUNCTION MELSEC-Q (e) The timing for external I/O enforced ON/OFF is shown in the table below. Refresh area Input • During END processing (input refresh) I/O modules on the base unit (X, Y) • During the execution of Output • During END processing (output refresh) • During the execution of commands that used direct commands that used direct access input (DX) (LD, LDI, AND, access output (DY) (OUT, SET, ANI, OR, ORI, LDP, LDF, ANDP, DELTA, RST, PLS, PLF, FF, LDF, ANDF, ORP, ORF) MC) I/O of Process CPU to • During END processing (MELSECNET/H refresh) be refreshed from LX, • During execution of the COM command LY of MELSECNET/H • During execution of the ZCOM command I/O of Process CPU to • During END processing (CC-Link refresh) be refreshed from RX, • During execution of the COM command RY of CC-Link 7 - 33 • During execution of the ZCOM command (f) A total of thirty-two devices can be registered for enforced ON and OFF. (g) Sequence program operations take precedence when used with an output Y contact. (h) The enforced ON, OFF and cancelled status (including those that are not set up) can be confirmed with GX Developer. Confirmation is also allowed with the MODE judgment LED when at least one device is registered. (the MODE LED will flicker.) (i) It is possible to register enforced ON/OFF for external I/O in the same CPU module from multiple GX Developers connected to the network. However, when enforced ON/OFF is registered in the same device from multiple GX Developers, it will assume the most recent registered ON/OFF status. Owing to this, there are cases when the GX Developer executed first will display different ON/OFF information to the CPU module ON/OFF information. When performing enforced ON/OFF from multiple GX Developers, ensure that the most up-to-date information is set with the "Load Registration Status" switch before executing the enforced ON/OFF procedure. 7 - 33
Related documents
QCPU(Q Mode)/QnACPU Programming Manual(Common
High Performance Model QCPU(Q Mode)User`s Manual(Function
User Guide - William Green
Q-series basic Course(for GX Developer)
Basic Model QCPU(Q Mode)User`s Manual(Function Explanation
MELSEC Syustem Q
MELSEC-L CPU Module User`s Manual (Function Explanation
Mitsubishi Q62DAN Specifications
High Performance Model QCPU(Q Mode)User`s Manual(Function
MultiBio700 User Manual
Model Q2AS(H)CPU(S1)User`s Manual
Process CPU User`s Manual(Hardware Design,Maintenance and