Download Display
Transcript
IMPORTANT! Check voltage polarity at the power cable connector. Reversing voltage polarity (swapping positive and negative leads) will damage your ClearPath and void the warranty. Teknic power supplies and cables are pre-tested for proper polarity. Never wire AC (wall current) directly to a ClearPath. IMPORTANT! ClearPath Operating Range 24-75VDC TEST POWER POLARITY BEFORE CONNECTING POWER TO CLEARPATH. Absolute Max. Voltage = 90VDC V+ 4 V+ 2 3 GND 1 GND VDC Power Cable Connector (viewed looking into connector) ANNI BII TII Teknic E3PS12-75 ClearPath Motor Power Supply Basic power polarity test Start with power supply unplugged and discharged. This will prevent electrical arcing from damaging your ClearPath power terminals over time. Always turn off and discharge your power supply before connecting or disconnecting the power cable from a ClearPath. If you hear an electrical “snap” when you plug in the power connector, you did it wrong. UNPLUG AND DISCHARGE power supply before disconnecting or connecting power to ClearPath. ANNI BII TII Teknic E3PS12-75 ClearPath Motor Power Supply Unplug and discharge the power supply before connecting it to your ClearPath Teknic, Inc. -3- ClearPath Quick Start Guide rev.1.7