Download Display

Transcript
IMPORTANT! Check voltage polarity at the power cable connector. Reversing voltage
polarity (swapping positive and negative leads) will damage your ClearPath and void
the warranty. Teknic power supplies and cables are pre-tested for proper polarity.
Never wire AC (wall current) directly to a ClearPath.
IMPORTANT!
ClearPath Operating Range
24-75VDC
TEST POWER POLARITY
BEFORE CONNECTING
POWER TO CLEARPATH.
Absolute Max. Voltage = 90VDC
V+ 4
V+ 2
3 GND
1 GND
VDC
Power Cable Connector
(viewed looking into connector)
ANNI
BII
TII
Teknic E3PS12-75
ClearPath Motor
Power Supply
Basic power polarity test
Start with power supply unplugged and discharged. This will prevent electrical arcing
from damaging your ClearPath power terminals over time. Always turn off and
discharge your power supply before connecting or disconnecting the power cable
from a ClearPath. If you hear an electrical “snap” when you plug in the power
connector, you did it wrong.
UNPLUG AND DISCHARGE
power supply before disconnecting
or connecting power to ClearPath.
ANNI
BII
TII
Teknic E3PS12-75
ClearPath Motor
Power Supply
Unplug and discharge the power supply before connecting it to your ClearPath
Teknic, Inc.
-3-
ClearPath Quick Start Guide rev.1.7