Download Matrix Electronic Pipettes

Transcript
Maintenance
3. Disconnect wire connectors.
Pull
apart
the
two
wire
connectors
over
the
battery
pack
(see Figure E.3.1Ab).
4.
Remove
battery
pack.
Pull
gently
on
the
battery
wire
connector
(without
the
pins)
to
dislodge
the
battery
pack,
then
lift
the
battery
pack
out
of
the
main
housing
(see Figure F.3.1Ac).
Figure F.3.1Ab: Disconnect Wires
5.
Insert
new
battery
pack.
Insert
the
new
battery
pack
into
the
cavity
of
the
main
housing.
Ensure
that
the
wire
is
looped
under
the
battery
pack
and
the
connector
is
above
it
(refer to Figure
F.3.1Ac).
NOTE: The
battery
pack
fits
very snugly in the main housing;
therefore, ensure that the pack
is oriented as shown in Figure
F.3.1Ac. The connectors for the
battery pack and the pipette
should be on opposite sides.
Figure F.3.1Ac:
Routing battery wires
6. Reconnect wire connectors.
Reconnect
the
wire
connectors
above
the
battery
pack.
Gently
push
the
wires
of
the
battery
pack
down
until
the
wire
connectors
lay
flat
over
the
top
of
the
battery
pack.
Figure F.3.1Ad: Reconnect Wires
45