Download Eddy Current Dynamometer Operator`s Manual
Transcript
MOUNTING THE DYNAMOMETER W Warranty Failure to follow these guidelines and procedures invalidates the DS warranty. Horizontal units should be mounted directly to a steel bed plate or T-slot base to ensure rigidity. Enclosure type dynamometers are self-supporting, but must be leveled, secured, and aligned. Pedestal type dynamometers are NOT self-supporting and must be mounted on a solid steel plate or T-slot base and then leveled, secured, and aligned. Units designed for horizontal mounting should NOT be mounted on an inclined plate unless they are designed for this purpose. When placing unit on mounting base, all foot pads must make contact. Whenever possible, connect the prime mover to the locked end of the shaft so axial movement due to thermal expansion will be away from the locked end. The unit must be level and equally supported on all mounting pads to avoid binding or mechanical failure. Use a feeler gauge between each pad and base to determine if shim stock is required before securing hold down bolts. Cut a single shim of the thickness required and slot it to slide under pad with bolt in place. Metal chips, dirt or burrs on the shim will make a point contact that prevents proper alignment. When the dynamometer is mounted on a base, use a machinist’s level to achieve precise level by shimming under the base foot pads. If foot pads do not exist, shim directly under the weight load which is typically directly under the pedestals. Failure to properly level the base will result in misalignment between the rotating units. It is not recommended to shim more than 1/8”. Excessive shimming can cause increased vibration. Dyne Systems • WATER-COOLED EDDY CURRENT DYNAMOMETERS DPD-002-04 • © Copyright Dyne Systems, Inc. 3 - Install & Setup 19