Download Gem Install.indd

Transcript
GEM series Installation Manual
Drawing 8258 Version 3.0.1
If You Read Nothing Else Read This page!
Follow these recommendations to minimize installation related problems.
Models 602, 603
· BE SURE that the display mounting screws do not penetrate the display face by more
than 1/8” inch or you will break the display. Instrument panels come in different thicknesses,
so the supplied screws may need to be shortened. Measure the portion of the screw which
protrudes from the back side of the panel to be certain.
· BE SURE that the display ground wire has a good low-resistance connection to the engine case. Improper grounding can cause erratic readings or damage the instrument.
ALL Models
· USE CAUTION when crimping the terminals onto the end of the GEM harness. Test each
crimp by tugging on it sharply. It is almost impossible to pull off a properly crimped terminal.
· KEEP the GEM harness at least 1 inch away from the ignition harness, P-leads, and alternator wiring. Some aircraft produce electrical noise which will cause erratic indications.
Page l