Download Final Document

Transcript
would be needed to achieve an output power of 1 watt. The transceiver has an operating
temperature range of -40 to 85 °C and can transmit at a data rate as low as DC with
external components and as high as 20 kbps. Narrowband operation required more
external components to improve performance. TH7122 had a sensitivity of -107 dBm and
had a cost of $13.40.
The last transceiver we considered was Analog Devices ADF7021. The ADF7021 had a
frequency range of 80 to 950 MHz. It is digitally programmable with modulation
schemes of FSK, 3FSK, 4FSK, and MSK. The chip has an adjustable output power of -16
dBm to 13 dBm which means that an external power amplifier would be needed to
achieve an output power of 1 watt. The transceiver has an operating temperature range of
-40 to 85 °C and can transmit at a data rate of 50 bps to 32.8 kbps without any external
components. The transceiver is designed as a narrowband transceiver with programmable
bandwidths of 12.5, 18.75, and 25 kHz. ADF7021 has a receiver sensitivity of -130 dBm
at 100 bps with on-chip image rejection calibration. It also had an on-board temperature
sensor and battery strength indicator.
We decided to use the Analog Devices ADF7021. It required fewer external components
compared to the Melexis TH7122. It also came with software that helped design the
component values of the external circuitry, performed simulations of the chip, and gave
register values to be programmed into the ADF7021 all based on our frequency, external
oscillator frequency, and bandwidth. The chip was also the cheapest at $5.76.
3.3.3. Detailed Design
The following section describes the detailed design for the VHF transceiver. This
includes diagrams, schematics, and simulation data.
3.3.3.1.
VHF Overview
The Analog Devices ADF7021 transceiver performs the modulation and
demodulation of the data sent from the microcontroller. ADF7021 outputs the
modulated data at a digitally programmable power range of -16 dBm to 13 dBm to an
external power amplifier SPA-1118 made by RFMD. This power amplifier has a
fixed gain of 17.2 db and an output power at 1db compression of 29.5 dBm. SPA1118 outputs to RF switch SKY13270-92LF made by Skyworks which connects the
RF output and RF input to a single 50 ohm antenna. For a block diagram, see Figure
5.
Wireless Bear Tracking, Group May1010
Page 31