Download Final Document
Transcript
would be needed to achieve an output power of 1 watt. The transceiver has an operating temperature range of -40 to 85 °C and can transmit at a data rate as low as DC with external components and as high as 20 kbps. Narrowband operation required more external components to improve performance. TH7122 had a sensitivity of -107 dBm and had a cost of $13.40. The last transceiver we considered was Analog Devices ADF7021. The ADF7021 had a frequency range of 80 to 950 MHz. It is digitally programmable with modulation schemes of FSK, 3FSK, 4FSK, and MSK. The chip has an adjustable output power of -16 dBm to 13 dBm which means that an external power amplifier would be needed to achieve an output power of 1 watt. The transceiver has an operating temperature range of -40 to 85 °C and can transmit at a data rate of 50 bps to 32.8 kbps without any external components. The transceiver is designed as a narrowband transceiver with programmable bandwidths of 12.5, 18.75, and 25 kHz. ADF7021 has a receiver sensitivity of -130 dBm at 100 bps with on-chip image rejection calibration. It also had an on-board temperature sensor and battery strength indicator. We decided to use the Analog Devices ADF7021. It required fewer external components compared to the Melexis TH7122. It also came with software that helped design the component values of the external circuitry, performed simulations of the chip, and gave register values to be programmed into the ADF7021 all based on our frequency, external oscillator frequency, and bandwidth. The chip was also the cheapest at $5.76. 3.3.3. Detailed Design The following section describes the detailed design for the VHF transceiver. This includes diagrams, schematics, and simulation data. 3.3.3.1. VHF Overview The Analog Devices ADF7021 transceiver performs the modulation and demodulation of the data sent from the microcontroller. ADF7021 outputs the modulated data at a digitally programmable power range of -16 dBm to 13 dBm to an external power amplifier SPA-1118 made by RFMD. This power amplifier has a fixed gain of 17.2 db and an output power at 1db compression of 29.5 dBm. SPA1118 outputs to RF switch SKY13270-92LF made by Skyworks which connects the RF output and RF input to a single 50 ohm antenna. For a block diagram, see Figure 5. Wireless Bear Tracking, Group May1010 Page 31