Download 1 - Electrocomponents
Transcript
FX Configurator-FP 7 Read / Write / Verify / Initialize Operation Manual 1 Writing [positioning/servo parameters and table information] Introduction 7.3 7.3 Writing [positioning/servo parameters and table information] Data writing procedures comprise of [Write to module] and [Flash ROM write]. 7.3.1 Writing to the BFM 2 1 Install Uninstall Start&Exit Writing [positioning parameters, servo parameters table information] to the 20SSC-H BFM. Operate any of the following procedures • Click [Write to module]. • Select [Online] → [Write to module]. 3 2 Window and Operation Config [Write to module] dialog box appears. Select the data to be written. 4 Creating Files 5 Data set 6 Description Displays [COM port] in [Connection setup] dialog box Displays [Transmission speed] in [Connection setup] dialog box Module No. Displays [Module No.] in [Connection setup] dialog box Item Ticks off the data to be read 7 Data flow And Procedure Transmission speed Positioning parameters Ticks off the axis of positioning parameters to be written • X-axis • Y-axis Servo parameters Ticks off the axis of servo parameters to be written • X-axis • Y-axis Table information Sets the writing range after ticking off the axis of table information to be written Setting range : 0 to 299 • X-axis • Y-axis • XY-axis <OK> Writes the selected data to the BFM *1. 9 Print Ticks off when writing the data selected in [Item] to Flash ROM 8 Debug In the Positioning Flash ROM write*1 <Cancel> Cancels selecting and closes the dialog box For the flash ROM write, refer to the following. → For the flash ROM write, refer to Subsection 7.3.2. Click <OK>. FX Configurator-FP writes the selected data to the 20SSC-H BFM. → For the displayed messages, refer to Section 7.6. 53 10 Edit Function In data 3 Setting The Connection Item COM port