Download Configuration Guide
Transcript
Configuration Steps for an Internet Connection 4. If you notice a problem, do the following: a. Reset the port. b. Check your configuration. c. Dial the ISP again. d. Repeat this procedure until the connection is made correctly. Contact your ISP if you are unable to connect as expected. The ISP might be able to provide additional information. 5. When you have configured the PortMaster correctly, enter the following commands to reset the port and save the configuration: Command> reset s1 Command> save all Testing the Network Hardwired Setup To test a network hardwired connection, follow these steps: 1. Reset the newly configured serial port. Command> reset s1 The network hardwired connection is normally established within a few seconds. 2. Verify that the port status is ESTABLISHED by entering the following command: Command> show s1 3. If there is a problem, check your configuration. Contact your ISP if you are unable to connect as expected. 4. When you have configured the PortMaster correctly, reset the port and save the configuration. Command> reset s1 Command> save all Using Internet Connections 18-9
Related documents
PortMaster Command Line Reference
Veritherm Betriebsanleitung Typ 40 - Bosy
FC5A Modbus Communication Training
miniHiPerCam - ELTEC Elektronik AG
FC5A Modbus Communication Tutorial
Overture VDM-10 Tool Support: User Guide
User manual
easyRAID ER820SR User Manual
Orion NAS 820SR User Manual
UM EN RAD-80211-XD... - Remote Site Products
100-013-686 MERLIN MAGIX Integrated System Installation
PortMaster® 4 User Manual Addendum