Download MC101

Transcript
01. SAFETY INSTRUCTIONS
02. THE CONTROL BOARD
▷ STANDARDS TO FOLLOW
TECHNICAL SPECIFICATIONS ◁
ATTENTION:
▷ Power supply
AC 230V 50/60Hz
▷ To ensure the safety of people, it is important that you read all the following
instructions.Incorrect installation or incorrect use of the product can cause physical
injury and material damage.
▷ Keep these instructions in a safe place for future reference.
▷ This product was designed and produced strictly for the use indicated in this
manual. Any other use, not expressly indicated here, could compromise the good
condition/operation of the product and/or be a source of danger.
▷ ELECTROCELOS SA is not responsible for the improper use of the product,
or other use than that for which it was designed.
▷ ELECTROCELOS SA is not responsible if safety standards were not taken
into account when installing the equipment, or for any deformation that may occur to
it.
▷ ELECTROCELOS SA is not responsible for the safety and proper operation
when using components not sold by them.
▷ Do not make any modifications to the operator components and / or their
accessories.
▷ Beffore installation unplug the automatism from the source of power.
▷ The installer must inform the client how to handle the product in case of
emergency and provide this manual to user.
▷ Keep remote controls away from children, to prevent the automated
system from being activated involuntarily.
▷ The customer shall not, under any circumstances, attempt to repair or tune
the automatism. Must call qualified technician only.
▷ Connect the automatism to a 230V plug with ground wire.
▷ Control board for indoor use.
▷ Motor output
1500W máx.
-20°C to 55°C
▷ Working temperature
433,92 Mhz
▷ Incorporated Radio Receptor
12 bits or Rolling Code
▷ OP Transmitters
46 Codes
▷ Maximum memory capacity
▷ Input Fuse (standard)
Ø5x20mm F5AL250V
DIPPERS FUNCTION ◁
LEGEND: Central
Dippers Scheme in
standard mode.
ON
OFF
1
2
3
4
ON (up)
OFF (down)
Dip 1
Enables automatic closing after
pause time.
Disables the automatic closing.
Dip 2
Enables the use/programming of 2
buttons either in transmitters as in
push buttons.
▷1 button opens and the other closes.
Enables the use/programming of
only 1 button in transmitters and
push buttons with the function
open-stop-close-stop (...).
Disables the PRESENT MAN
function in closing maneuvers.
Enables the PRESENT MAN function
in closing maneuvers.
(it’s necessary to keep the key
pressed down to close).
Disables the photocells use
(CN2-10).
Enables the photocells use
(CN2-10).
Dip 3
Dip 4
01.A
12 VDC - 1W - 80mA máx.
▷ Auxiliary accessories output
01.B