Download Basic Configuration
Transcript
Basic Configuration Using a Script to Configure the Server for Xremote Support This section includes an access server script that specifies server parameters and port characteristics for Xremote support. This is a sample script, but you can modify it for the implementation at your site. It assumes that you have enabled Xremote on the access server. This script is installed on a UNIX host on the network. You associate a script with a port with the SET PORT SCRIPT command. See the Advanced Features Guide for more information about how to create and install access server scripts. Comment lines begin with #. Comment lines that appear on the user's screen begin with #echo. #control_script #echo This script initializes the ACCESS SERVER for running Xremote #echo #echo Make sure to enable the Xremote protocol on the access server #echo before you execute the script with the DEFINE SERVER PROTOCOL XREMOTE #echo your ENABLED command. You must enter a password to enable Xremote. See #echo Xyplex sales representative if you need a password. # # Enter privileged mode and specify server characteristics. # Customize font servers for the access server. set priv system define server xremote primary font server 123.123.123.123 set server xremote primary font server 123.123.123.123 # define server xremote secondary font server 123.123.123.124 set server xremote secondary font server 123.123.123.124 # #echo This script initializes ports 1-4 for Xremote. #echo To view configuration changes, use these commands: #echo show server xremote, show port, #echo show port alternate characteristics, #echo show port telnet characteristics # define port 1-4 modem enabled define port 1 telnet remote 6001 define port 2 telnet remote 6002 define port 3 telnet remote 6003 define port 4 telnet remote 6004 define port 1-4 typeahead size 1024 define port 1-4 internet tcp window size 512 define port 1-4 session limit 16 0084 129