Download Basic Configuration

Transcript
Basic Configuration
Using a Script to Configure the Server for Xremote Support
This section includes an access server script that specifies server
parameters and port characteristics for Xremote support. This is a sample
script, but you can modify it for the implementation at your site. It
assumes that you have enabled Xremote on the access server. This script is
installed on a UNIX host on the network. You associate a script with a port
with the SET PORT SCRIPT command. See the Advanced Features Guide
for more information about how to create and install access server scripts.
Comment lines begin with #. Comment lines that appear on the user's
screen begin with #echo.
#control_script
#echo This script initializes the ACCESS SERVER for running Xremote
#echo
#echo Make sure to enable the Xremote protocol on the access server
#echo before you execute the script with the DEFINE SERVER PROTOCOL
XREMOTE
#echo
your
ENABLED command.
You must enter a password to enable Xremote.
See
#echo Xyplex sales representative if you need a password.
#
# Enter privileged mode and specify server characteristics.
# Customize font servers for the access server.
set priv system
define server xremote primary font server 123.123.123.123
set server xremote primary font server 123.123.123.123
#
define server xremote secondary font server 123.123.123.124
set server xremote secondary font server 123.123.123.124
#
#echo This script initializes ports 1-4 for Xremote.
#echo To view configuration changes, use these commands:
#echo show server xremote, show port,
#echo show port alternate characteristics,
#echo show port telnet characteristics
#
define port 1-4 modem enabled
define port 1 telnet remote 6001
define port 2 telnet remote 6002
define port 3 telnet remote 6003
define port 4 telnet remote 6004
define port 1-4 typeahead size 1024
define port 1-4 internet tcp window size 512
define port 1-4 session limit 16
0084
129