Download Post Processing

Transcript
FeatureCAM General Post Processor
current and previous segments, thereby allowing for the tool to be retracted from
the part, to a safe plane.
3. Use of the <Z-COORD> Reserved Word is optional for PROGRAM START and
TOOL CHANGE program formats. It is calculated in the following manner:
•
<Z-COORD> = TL CHG (Z)
•
TL CHG (Z) is programmed in FeatureCAM
4. Whether <Z-COORD> is used or not, Post assumes that the tool is at this Z level,
after the code for any of the aforementioned formats is generated.
NOTE:
The TOOL CHANGE format is output only if there is a change in tool
number between segments. If there is not a change in tool number, the
SEGMENT START format is output.
Program start rules
1. Post outputs lines that are defined in PROGRAM START at the beginning of a
program. In PROGRAM START, general preparatory codes (e.g., absolute,
incremental, etc.) are placed to define the dimension system.
2. The first tool change must also be defined.
3. Functions such as, <SPEED>, <SPINDLE> and <COOLANT> status can be
passed to the Post output with the first positioning move via <X-COORD> and
<Y-COORD>.
4. If the target machine tool uses fixture offsets (G54, G55/E1, E2), the Reserved
Word <FIXTURE> should be positioned before the <MOTION> <X COORD> and
<YCOORD> words.
Tool change rules
1. A TOOL CHANGE block is output between segments that require a tool change.
2. This block is only output if the Tool # specification (FeatureCAM) differs from the
previous one.
3. Functions such as, <SPEED>, <SPINDLE> and <COOLANT> status can be
passed to the Post output with the first positioning move via <X-COORD> and
<Y-COORD> Reserved Words.
4. If the target machine tool uses fixture offsets (G54, G55/E1, E2), the Reserved
Word <FIXTURE> should be positioned before the <MOTION> <X COORD> and
<YCOORD> words.
Segment start rules
1. SEGMENT START is only output between non-tool changing segments.
2. SEGMENT START should contain any commands that may change between
segments (e.g., <SPEED>, <COOLANT>, etc.).
3. The Reserved Words: <X-COORD>, <Y-COORD> and <Z-COORD>, must be
included in SEGMENT START.
4. If the target machine tool uses fixture offsets (G54, G55/E1, E2), the Reserved
25