Download Post Processing
Transcript
FeatureCAM General Post Processor current and previous segments, thereby allowing for the tool to be retracted from the part, to a safe plane. 3. Use of the <Z-COORD> Reserved Word is optional for PROGRAM START and TOOL CHANGE program formats. It is calculated in the following manner: • <Z-COORD> = TL CHG (Z) • TL CHG (Z) is programmed in FeatureCAM 4. Whether <Z-COORD> is used or not, Post assumes that the tool is at this Z level, after the code for any of the aforementioned formats is generated. NOTE: The TOOL CHANGE format is output only if there is a change in tool number between segments. If there is not a change in tool number, the SEGMENT START format is output. Program start rules 1. Post outputs lines that are defined in PROGRAM START at the beginning of a program. In PROGRAM START, general preparatory codes (e.g., absolute, incremental, etc.) are placed to define the dimension system. 2. The first tool change must also be defined. 3. Functions such as, <SPEED>, <SPINDLE> and <COOLANT> status can be passed to the Post output with the first positioning move via <X-COORD> and <Y-COORD>. 4. If the target machine tool uses fixture offsets (G54, G55/E1, E2), the Reserved Word <FIXTURE> should be positioned before the <MOTION> <X COORD> and <YCOORD> words. Tool change rules 1. A TOOL CHANGE block is output between segments that require a tool change. 2. This block is only output if the Tool # specification (FeatureCAM) differs from the previous one. 3. Functions such as, <SPEED>, <SPINDLE> and <COOLANT> status can be passed to the Post output with the first positioning move via <X-COORD> and <Y-COORD> Reserved Words. 4. If the target machine tool uses fixture offsets (G54, G55/E1, E2), the Reserved Word <FIXTURE> should be positioned before the <MOTION> <X COORD> and <YCOORD> words. Segment start rules 1. SEGMENT START is only output between non-tool changing segments. 2. SEGMENT START should contain any commands that may change between segments (e.g., <SPEED>, <COOLANT>, etc.). 3. The Reserved Words: <X-COORD>, <Y-COORD> and <Z-COORD>, must be included in SEGMENT START. 4. If the target machine tool uses fixture offsets (G54, G55/E1, E2), the Reserved 25