Download RF Lock-In Amplifier - Frederick Seitz Materials Research Laboratory
Transcript
3-18 CH1 Display and Output Important! Ratio • Except for R[dBm], the offset is specified as a percentage of full scale sensitivity. Changing the sensitivity requires the offsets be changed to offset the same input signal. • Changing the Reference Phase will modify the values of Xoffset and Yoffset. (Xoffset, Yoffset) is a signal vector relative to the Reference (internal or external) which cancels an actual signal at the input. This cancellation is preserved even when the detection phase (Reference Phase) is changed. This is done by circularly rotating the values of Xoffset and Yoffset by minus the Reference Phase. This preserves the phase relationship between (Xoffset, Yoffset) and the signal input. Ratio mode divides both X and Y by the input voltage AUX IN 1 or AUX IN 2. The ratio input is normalized to 1.000 Volt, so that ratioing by an Aux Input that is a steady 1.000 V is exactly the same as having the ratio mode Off. The useful range of the Aux Inputs, when in ratio mode, is from about 0.1 Volt to 10 Volts. Both positive and negative voltages are permitted. The Ratio key selects the ratio mode. The ratio mode may be Off, divide by AUX IN 1 or AUX IN 2. The AUX IN 1 and AUX IN 2 indicators above the Ratio key show the ratio mode if it is on. Both indicators are off when ratio mode is Off. The instrument has a single ratio mode, which applies to both X and Y. The CH2 AUX IN 1 and AUX IN 2 indicators follow the CH1 indicators. In Ratio Mode, the non-ratioed quantities are not available. When the ratio mode is on, the ratio is performed after X and Y offsets are applied and before the output time constant filters. This allows the offsets to cancel a signal at the input before applying the ratio. R and θ are computed from ratioed X and Y. Thus, R is ratioed the same as X and Y. The ratio shows up as a dBm offset in R[dBm]. Xnoise is computed from the ratioed X. For example, if the ratio mode is AUX IN 2 and the AUX IN 2 input is a steady 2 volts, X and R[V] will be ½ their non-ratioed values, R[dBm] will be down by 6 dB and Xnoise will also be down a factor of 2. Ratio is not applied to AUX IN 1. Note that the effects of ratio mode on Xnoise may be several. A steady Aux Input will linearly scale the Xnoise as just mentioned. If the variations of the Aux Input are positively correlated with signal variations, as might be expected in situations where the input signal is dependent on the Aux Input, then Xnoise in ratio mode may be much lower than the non-ratioed value. If the variations of the Aux Input are uncorrelated with signal variations, or negatively correlated, then the Xnoise in ratio mode may be greater than the non-ratioed value. OVERFLOW UNDERFLOW The OVERFLOW indicator shows that the ratio Aux Input exceeds the input range (±10.5 V). The ratioed outputs are no longer correct in this case. SR844 RF Lock-In Amplifier