Download Simulation - Agilent Technologies

Transcript
Simulation
Phase Noise Specification
Phase noise is specified by two lists.
•
A list of frequency offsets
•
A list of power levels in dBc/Hz
Phase noise can also be specified single or double sided. If double sided negative offset
frequencies must be used.
NOTE: There must be the same number of entries in both frequency and amplitudes
lists. If not a warning will be issued and the lists will be truncated to the smaller of the two
lists.
The following example shows the single sided specification of an oscillator. In this
example, phase noise is specified for -70, -90, -100, -105, and -110 dBc/Hz for the
respective offset frequencies of 1, 10, 100, 1000, 10000 kHz. The carrier center frequency
is 1530 MHz.
162