Download Preface - Sion electronics

Transcript
194
Care And Maintenance
9.2 Inspection and displacement of the vulnerable components
During operation, some components of frequency inverter may wear or the performance is
slowed down. In order to ensure the stable reliable operation of frequency inverter, the users
shall carry out preventative maintenance for frequency inverter, and replace the components
when necessary.
9.2.1
Filter capacitor
1. Possible cause of damage: Environmental temperature and the pulsating current are high,
and electrolyte is aging.
2. Assessment criterion: When frequency inverter operate with load, uses check whether there
occur fault such as over current, over voltage; whether liquid leaks out, whether the relief
valve bulge; whether the determination of electrostatic capacitive and insulation resistance
are abnormal.
3. The pulsating current of main loop would affect the performance of the aluminum electrolysis
filter capacitor, and the degree of influence depends on the environment temperature and the
using conditions. Replace electrolytic capacitors of frequency inverter every three to four
years under normal conditions.
4. Filter capacitor shall be replaced immediately if any of the following occurs: electrolyte of the
electrolyte capacitor leaks, relief valve emits out, and subject of the capacitor expands.
9.2.2
Cooling fan
1. Possible cause of damage: Bearing wearing, leaf aging, etc.
2. Assessment criterion: When the power of frequency inverter is cut out, check the fan blades
and other parts to see whether there is any abnormality such as crack. With the power on, just
check whether the fan operation situation is normal, and whether it has abnormal vibration
and noise.
3. Service life of the entire cooling fan in frequency converter is about 15000 hours (i.e.
frequency inverter use continuously for about two years), if the fan has unusual voice or
vibration, it should be replaced immediately.
V350 Low-Power Closed-Loop Vector Inverter User Manual