Download ENG
Transcript
14.6 CxHy sensor for measurement of the unburnt hydrocarbons The unburnt hydrocarbons are chemicals produced by an incomplete combustion of molecules (hydrocarbons) made of Carbon and Hydrogen. These are usually named as HC or (better) CxHy: when this is filled with the actual values for the number of C and H atoms, the actual type of fuel is exactly defined. In case of Methane, as an example, the correct formula is CH4. In the following table is shown the cross sensitivity of the CxHy sensor when exposed to fuels different from Methane (CH4), assumed as 1.00. GAS / VAPOR RELATIVE RESPONSE (with respect to Methane) GAIN ADJUSTMENT Ethanol 0.75 1.33 Iso-Butane 0.60 1.67 Methane 1.00 1.00 Methanol 1.00 1.00 n-Butane 0.60 1.67 n-Heptane 0.45 2.22 n-Hexane 0.50 2.00 Propane 0.70 1.43 Calculation example: Type of gas: Relative response: Gain adjustment: Reading value (related to metane): iso-butane 0.6 1.67 1.34 Value = reading value x gain adjustment Example: 1.34 x 1.67 = 2.24 WARNING Gas vapors which containsilicone compounds (HMDS) can irreversibly damage the sensor. 14.6.1 Installing the CxHy sensor When the CxHy (position S3/S4) is mounted in the instrument, it is mandatory to configure the autozero by setting it at 180 seconds, in order to allow for a proper pre-heating of the sensor itself. The instrument battery life, once the CxHy is installed, lasts 10 hours, provided no printing is made. Configuration→Analysis→Autozero (SEE SECTION 9.2.6) 15/01/14 10:00 15/01/14 10:00 Configuration Autozero Autozero s Purging s 15/01/14 10:00 Configuration Autozero 60 Autozero 0 Purging Autozero Configuration Autozero Autozero 180 s Purging 0 s 15/01/14 10:00 Configuration Autozero 060 s → s 180 s Purging 0 0 s OK O OK O OK 126 O O K000000000SE 024435 160115