Download User Manual
Transcript
2-20 Close/Open Switching Module Channels Model 2701 User’s Manual Multiple channel operation anomalies • • NOTE Anomaly #1 — When you use multiple channel operation to open the system channel, the channel will open but the system channel number will still be displayed on the Model 2701. For details, see “Anomaly #1 example — wrong channel displayed.” Anomaly #2 — For a 4-wire function, you can use multiple channel operation to open the paired channel. If you then use system channel operation to again select the already closed system channel it will not re-close the paired channel. For details, see “Anomaly #2 example — opening the paired channel.” The following anomaly examples assume a Model 7700 installed in slot 1. Anomaly #1 example — wrong channel displayed The following example closes channel 102 and connects it to the DMM Input. However, the Model 2701 will not display the measurement channel that is closed. It will display channel 101 instead of channel 102. 1. 2. 3. 4. Use the ALL option for the OPEN key to open all channels in the mainframe. Remote programming: ROUT:OPEN:ALL Press the 䊳 key to close (and display) channel 101. This closes channel 101 (which is the system channel) and channel 125 to connect it to the DMM Input (Figure 2-1). Remote programming: ROUT:CLOS (@101) Use the MULTI option for the CLOSE key to close channel 102. The system channel is not affected. Channels 101, 102, and 125 are now closed. Remote programming: ROUT:MULT:CLOS (@102) Use the MULTI option for the OPEN key, open channel 101. Even though channel 101 is still being displayed on the Model 2701, it is channel 102 that is actually connected to the DMM Input (channels 102 and 125 closed). Remote programming: ROUT:MULT:OPEN (@101) To correctly display the channel that is closed (channel 102), repeat step 1 above to open all channels and then use the 䊳 key or the ROUT:CLOS (@102) command to close (and display) channel 102. This closes channel 102 (which is the system channel) and channel 125 to connect it to the DMM Input.
Related documents
Model 2700 Multimeter/Switch System
User`s Manual
Manual - Test Equipment Depot
Training Manual - System Administration V4-7
Model 2701 Ethernet-Based DMM / Data Acquisition
Model 27XXIntegra Series Quick Start Guide
STATus:QUEStionable:TEMPerature?
EX1200 SERIES - VTI Instruments
DMM4040 and DMM4050 Digital Multimeter Programmer
INSTRUCTION MANUAL
User`s Manual
Series 2400 SourceMeter User`s Manual