Download SINUS M

Transcript
① Accelerate for accel time up to setting frequency by Drive 1 mode, FX signal.
② Drive continuously under FX is ON because DRV2 is 1 when P8 terminal input is ON and
change into 2nd.
③ Stop gradually as stop command because DRV is communication drive when P8 terminal
input is OFF and change into 1st.
④ Accelerate up to setting frequency for Drive 1 mode, FX signal is ON.
⑤ Stop gradually under FX is OFF because DRV2 is 1 when P8 terminal input is ON and
change into 2nd.
CAUTION
If you press ON while multi-function input terminal (P1 ~ P8) is set to 2nd Source,
frequency command and drive command is changed to Drive mode 2. So you
should check Drive mode 2 before configuring the multi-function terminal.
10-36