Download SINUS M
Transcript
① Accelerate for accel time up to setting frequency by Drive 1 mode, FX signal. ② Drive continuously under FX is ON because DRV2 is 1 when P8 terminal input is ON and change into 2nd. ③ Stop gradually as stop command because DRV is communication drive when P8 terminal input is OFF and change into 1st. ④ Accelerate up to setting frequency for Drive 1 mode, FX signal is ON. ⑤ Stop gradually under FX is OFF because DRV2 is 1 when P8 terminal input is ON and change into 2nd. CAUTION If you press ON while multi-function input terminal (P1 ~ P8) is set to 2nd Source, frequency command and drive command is changed to Drive mode 2. So you should check Drive mode 2 before configuring the multi-function terminal. 10-36