Download My Document - MicroStrain

Transcript
Node Commander® Software User Manual
9.2
Sampling Modes and Settings
Synchronized Sampling
Synchronized sampling is the most capable and accurate sampling method. Sample rates are
set by the user and there is a burst mode for high speed, short duration sampling. Event based
sampling is also available with pre and post event data saving options.
In standard synchronized sampling, the sampling can be set to repeat for a fixed interval of time
after the sampling has been started or continuously until a stop command is sent. In burst
sampling, the duration of the burst and time between bursts is configurable. The sampling
repeat interval is limited to one day. In event based sampling, the data will be continuously
sampled but only recorded when it meets the event criteria. The node can also be configured to
store the data in the node memory, to store the data and transmit it to the gateway, or to
transmit only. A time stamp is obtained from the host computer when sampling is started. Each
sample is then incrementally stamped based on that starting point and the node clock.
To adjust synchronized sampling settings, open the node configuration menu by right clicking
on the node name and then selecting Configure, Configure Node. Select the Synchronized
Sampling tab. Key menu options include the burst and event based sampling features.
Figure 73 - Synchronized Sampling Settings
83