Download Installation Guide
Transcript
• HOLD: Hold function key, VoIP do not disturb function programming: Network Æ WAN Setup Æ Fixed IP key setting to set IP address, subnet mask and default gateway. After then get into LCD programming: DNS Æ • SPEAKER: Hands free key Primary DNS and Secondary DNS to set DNS server Use Keypad to set this device: Key 1 1-,!? 2 2abcABC 3 3defDEF 4 4ghIGHI 5 5jklJKL 6 6mnoMNO 7 7pqrsPQRS 8 8tuvTUV 9 9wxyzWXYZ 0 0 ‘空格’ * *. : @ # 6 If your device should use PPPoE, e.g. ADSL, please use Input Character LCD programming: Network Æ WAN Setup Æ PPPoE setting to set the PPPoE account and Password. • Press ESC repeatedly till it show ‘Please Reboot’, then power off the device and power on it. 8 Automatically get configuration If your VoIP service provider has pre-set your device, it should automatically get configuration from the Internet after it is powered on. And then it will reboot automatically and ready for use. 9 Ready for use Your device should be ready for use now, it will show these information on LCD. Date Authentication Time MM-DD XX:XX < XXXXXXX > For admin user: 1st account Account: root Password: test For normal user:(With this account you can not set some parameters, e.g. SIP setting) If your device isn’t the ready to use status, it means you should set it your self. Please see chapter10 and 11 if you should set if yourself. Account: user Password: test 10 Use phone LCD programming to set Attention: if your password be changed when you Refer to chapter 12 to learn how to set LCD programming: get your device, please contact with the distributor SIP Settings and NAT transversal, then ask your VoIP of this device. service provider how to set/select these parameters. Keep the default parameters if you haven’t got the answer for 7 Use phone to set net work parameters Please check chapter 12 to know how to use the LCD and keypad for programming. At first, please ask for your network administrator or ISP to know your IP type. The default network setting of this device is DHCP IP type, if your network can not accept DHCP access, please set it as follows: • LCD programming: Network Æ WAN Setup Æ IP type to select your IP type. • If your device should use static IP, please use LCD how to set/select some of these parameters. • LCD programming: Administrator Æ System Authent, input the password of root account. (See chapter 6) • LCD programming: SIP Setting and set all parameters here. • LCD programming: NAT transversal Æ STUN setting and set all parameters here. • LCD programming: Phone setting Æ Date/Time set set all parameters here. • Press ESC repeatedly till it show ‘Please Reboot’, then