Download 6205 system

Transcript
5-7
4. Check Chan 4 on Com 4 from the drop down list to see if there is any data being reported by the
port.
5. If no data is present, cycle the power on the sonar head using the On/Off switch on the interface
box. Please allow the sonar to be off for at least 10 seconds before turning it back on.
6. Once the sonar is reconnected, go back into the Remote Desktop application and check Chan 4
on COM 4 again as in step 4 above.
7. If data is reported by the port, then proceed to normal operation. If not, continue to step 8.
8. Close out of Sonar.exe by clicking on the ‘X’ in the top right corner (designated by the red arrow
in Figure 5-8).
Figure 5-8: Closing the Sonar.exe Application
9. Double click the “Shortcut to EdgeTech” icon, then navigate to the Utilities/Teraterm folder, and
launch the ttermpro.exe program.
10. Select Serial, choose COM4 from the drop down menu (Figure 5-9), and click OK.
11. Now, choose Setup from the top menu and then Serial port…
12. Configure the serial port options as shown in Figure 5-10 and click OK.