Download WASSP

Transcript
Installation Manual
8.3
WASSP Transfer Task Settings
The WASSP Transfer Task has four tabbed pages for configuring serial transfer settings:
►►
►►
►►
NMEA Settings tab page. See”Figure 19. NMEA Settings Tabbed Page” on page 30
Network Settings tab page. See “Figure 22. WASSP Network Settings Tabbed Page” on
page 31
RTS/CTS
The NMEA and WASSP tabbed pages allow you to configure a number of NMEA and WASSP
set up and communication port settings.
To open the Serial Task Transfer box and enter the NMEA and WASSP set up and
communication port settings:
1
Right-click the WAASP Transfer Task icon
on the Windows Task bar. Click Setup.
The WAASP Transfer Task opens.
2
Note: If the WASSP Transfer Task
icon is not available on the Task
Bar, click Start > All Programs >
WASSP > Transfer Task.
The NMEA Settings are used to configure the transport protocol between
sensors and the WASSP system.
Select the appropriate COM Port and configure as required for the sensor.
The Activity indicator will show
data activity. Green is connected
and active, clear is not active
and red indicates an error on the
COM port.
Click Monitor box to see the
actual Sentences from the sensor
in the display area.
The display area.
Figure 21. WASSP NMEA Settings Tabbed Page
Page 30 of 73
www.wassp.com
Doc. P/N: WSP-009-005
Version:
V1.2
Issue Date: August 2012