Download Sima VS-HD14 Specifications
Transcript
YES PRODUCT DESCRIPTION TECHNICAL PERFORMANCE CRITERIA: RUST PROTECTION SPECIFICATIONS: MEGAFLEX The second arm shall pivot freely on the primary swing arm and be orientated opposite the rear cross tube to provide gravity assisted downward force to hold the tarp behind the cab shield and minimize tarp lifting or sailing To prevent the rear swing arms from lifting or bouncing when the tarp is in the closed position, the system shall be equipped with locks near the rear cross tube that automatically engage when the tarp is fully closed, and immediately unlock when the process to open the tarp is initiated. Product shall be acrylic, abrasion resistant, rust preventive coating. must be one part acrylic base self priming, thixotropic Coating semi-paste coating that contains at least 36% highly elastic in water dispersed polymers. V.O.C. (volatile Organic Compound) shall be 0.01 or less as evidenced by OSHA Form 174 MSDS. Coating cannot contain any lead, organic solvents, or bitumastic materials or other hazardous ingredients as evidenced by OSHA Form 174. Coating shall be 100% waterproof. Coating must be 100% ultraviolet resistant so as not to breakdown as a result of long term exposure to sunlight. Coating must be capable of 200% elongation so as to completely prevent cracking due to expansion and contraction as well as dimpling resulting from impacts. Coating must afford excellent chemical resistance to acids alkalis, salts and fuels. Coating must be self-extinguishing. Coating must dry to a smooth texture. Coating dry film thickness shall be 14 mil. Coating samples wet and dry shall be submitted for evaluation at the time of the bid if supplying an alternate product. Coatings offered shall have been tested in the following areas. Results as listed below shall be considered the minimum acceptable to the County. Test documentation must be available upon request. Specific Gravity: Not less than 1.28 Solids by Weight: Not less than 57% Spread Rate: 400 grams per sq./meter @ 13 mils Dry Time: 30 minutes at 70ºF. and 50% relative humidity. Cure Time: 48-72 hours after final coat. Application Temperature: Not less than 45º on substrate. Primer: 33 diluted Magaflex. Elasticity: 200% NO