Download Code CR3600DPM Technical information

Transcript
10/29/2014
Reg
Setting Name
159
Ignore Duplicate Code
(ms)
172
173
Automatically save the
Bluetooth connection
address
Enable Bluetooth
Encryption
Default
(Hex)
0
Comment
Valid Range: 0 to 7FFFFFF Milliseconds
Consecutive duplicate codes (i.e., codes that contain the same
data) are blocked for this amount of time (in milliseconds). 0 turns
off blocking of duplicate codes.
CR2300:
CR2600:
CR3600:
1
0
Also see register: 21C, 2CA
0: Disable
1: Enable
The address in the QuickConnect code will be saved if enabled.
Note: Only applies to readers using Bluetooth communication
modes.
0: Disable
1: Enable
Full wireless link encryption support for Bluetooth readers added in
0476+.
181
1EA
20E
218
Glare Detection
(Reduction)
Good Read Duration
(ms)
0
Motion Detection: Start
Delay (ms)
0
Motion Detection
Option
C8
(#200)
Note: PIN must be set to the same value on the reader and remote
device for connection to be successful. For Code Modems, please
refer to the D018582 Modem ICD document for details on the
setPin command.
0: Disabled
1: Enabled
Valid Range: 0 to 7FFFFFF Milliseconds
Affects beep and vibrate duration.
Valid Range: 0 to 7FFFFFFF Milliseconds
A built-in delay of 200 ms prevents motion detect from detecting
motion right after a successful decode. This allows the barcode to
be removed without triggering a new decode. Use this register to
add an additional delay amount to the built-in delay.
0
Also see registers: 86, 204, 20E
Binary Dip Switch with bits 1 & 2 comprising a value
Bit
Controls
1
2
CR6000
Illumination
Value
0: Dark Field illumination
1: Diffuse Bright Field
2: Direct Bright Field
3: Dark Field and Diffuse
Bright Field
Page 47 of 72
© 2014 The Code Corporation  12393 South Gateway Park Place Suite 600, Draper, UT 84020  (801) 495-2200  FAX (801) 495-0280